Store PLCnext CommunityPLCnext on LinkedInPLCnext on Instagram  PLCnext on YouTube Github PLCnext CommunityStore PLCnext Community

  1. Rob H
  2. PLCnext Engineer
  3. Tuesday, 04 February 2020

I updated a project from 2019.9 to 2020.0 and now I cannot map the data for the IO-Link master correctly. When I try to set the submodule type for each port, the list for the types of device is blank. The info for the IO-Link master, ICE1-8IOL-G60L-V1D, can be found in the link below. 

https://www.pepperl-fuchs.com/usa/en/classid_4996.htm?view=productdetails&prodid=86682#software

Automation Engineer - Grand Rapids, MI, USA

Martin PLCnext Team Accepted Answer Pending Moderation
0
Votes
Undo

Hi Rob,

At the moment the workaround for this problem is to copy the Submodule from Components, and replace it under the Submodules from the IOL Master.

I hope this makes sense. (if not, let me know).

~ Martin.

Phoenix Contact Electronics Headquarters - PLCnext Runtime Product Management and Support

  1. more than a month ago
  2. PLCnext Engineer
  3. # 1
  • Page :
  • 1


There are no replies made for this post yet.
However, you are not allowed to reply to this post.