PLCnext on LinkedInPLCnext on Instagram  PLCnext on YouTube Github PLCnext CommunityStore PLCnext Community

Resolved Bar Graph

0
Votes
Undo
  1. vince
  2. PLCnext Engineer
  3. Tuesday, 03 March 2020

Hello,

We are working with machines which can extend/retract. Now I have made a program to calculate the length of the machine part and thus how much it can extend/retract. Is it possible for a Bar Graph (or alike) to set the scale from 0 to this calculated value? It would save a lot of hassle with operating the machine first so the length is known, then set it as the max value on the scale and re-operate the machine again since with writing to the plc it has lost this value.

Martin PLCnext Team Accepted Answer Pending Moderation
0
Votes
Undo

Hi Vince, sorry for the delay. This question is currently with our eHMI team, and they are getting daily reminders that you are still waiting for an answer.

We'll let you know as soon as we hear anything.

~ Martin.

Phoenix Contact Electronics Headquarters - PLCnext Runtime Product Management and Support

  1. one week ago
  2. PLCnext Engineer
  3. # 1
Martin PLCnext Team Accepted Answer Pending Moderation
0
Votes
Undo

Hi Vince,

We finally have an answer to your question. I am sorry to say that this feature is not currently planned for the PLCnext eHMI.

~ Martin.

Phoenix Contact Electronics Headquarters - PLCnext Runtime Product Management and Support

  • Page :
  • 1


There are no replies made for this post yet.
However, you are not allowed to reply to this post.