Store PLCnext CommunityPLCnext on LinkedInPLCnext on Instagram  PLCnext on YouTube Github PLCnext CommunityStore PLCnext Community

Toggle Submenu
  1. Forums
  2. Recent
  3. Categories
Add a reply View Replies (3)

Resolved Could not start an existing PLC application on a AXC 2152 after firmware update.to 1.02.

0
Votes
Undo
  1. pynl02
    pynl02
  2. PLCnext Technology & PLCnext Controls
  3. Friday, 16 March 2018

If done the update to 1.02 this week and after the update an existing project does not start anymore. I have some C++ library if written and a simple application with some IO's. With the original firmware the project was working without any Porblems. But now if I try to download the application to the AXC 2152 is not connectable from PCWorxEngineer. With WinSCP I could connect.

When I remove the Project from the PLC, The AXC 2152 is starting again and I could work normally. A simple project adressing some DOs only with IEC 61131 code also works.

  1. PLCnext
Accepted Answer
Vincent PLCnext Team
Vincent PLCnext Team Accepted Answer Pending Moderation
0
Votes
Undo

Did you upgrade from version 1.0.0? if so, you probably haven't updated the C++ SDK.

This is mandatory to get the latest C++-sdk, and recompile your library.

Phoenix Contact Netherlands - Technical Consultant

  1. more than a month ago
  2. PLCnext Technology & PLCnext Controls
  3. # Permalink
Responses (3)
pynl02
pynl02 Accepted Answer Pending Moderation
0
Votes
Undo

Works for thanks. Do I always need to update the SDK? Were kann I get information about the fact that a new SDK is needed for a Firmware version?

  1. more than a month ago
  2. PLCnext Technology & PLCnext Controls
  3. # 1
Dzmitry Ivaniuk
Dzmitry Ivaniuk Accepted Answer Pending Moderation
0
Votes
Undo

Hello,

As variant you can check download area for corresponding SDK versions.

  1. more than a month ago
  2. PLCnext Technology & PLCnext Controls
  3. # 2
  • Page :
  • 1


There are no replies made for this post yet.
However, you are not allowed to reply to this post.