PLCnext on LinkedInPLCnext on Instagram  PLCnext on YouTube Github PLCnext CommunityStore PLCnext Community

  1. bmmsantos
  2. Proficloud
  3. Monday, 27 April 2020

Hello,

I built the sample program to test the connection of my PLC to the proficloud, but when i try to read them or locate them on the proficloud page it starts an infinite cycle saying "turn on your appliance".

I´ve been folloing the above tutorial and i get stuck around minute 2:23.

Been trying all sorts of tutorials or videos for the last couple weeks or so and i feel that i hit a wall, if someone can guide me i would apreciate 

Thank you in advance

 

 

Attachments (3)
dhoysan Accepted Answer Pending Moderation
0
Votes
Undo

Looks like that video skips the step where you setup the internet connection of the PLCnext. Make sure PLCnext has an active internet connection and you should be good.

  1. more than a month ago
  2. Proficloud
  3. # 1
Arno PLCnext Team Accepted Answer Pending Moderation
0
Votes
Undo

Hi,

It looks like the device can not reach the profilcoud. Did you check the Gateway-Address? Is the RTC set to UTC?


Phoenix Contact Electronics Headquarter - Support Center

  1. more than a month ago
  2. Proficloud
  3. # 2
  • Page :
  • 1


There are no replies made for this post yet.
However, you are not allowed to reply to this post.