Store PLCnext CommunityPLCnext on LinkedInPLCnext on Instagram  PLCnext on YouTube Github PLCnext CommunityStore PLCnext Community

Toggle Submenu
  1. Forums
  2. Recent
  3. Categories
Add a reply View Replies (1)

Resolved IED Configurator Failure

  1. Send to ticket
0
Votes
Undo
  1. milosav.sekaric@elektrovat.net
    milosav.sekaric@elektrovat.net
  2. PLCnext Technology & PLCnext Controls
  3. Thursday, 18 February 2021

Dear Colleagues,

 

I have one problem.

 

I have AXC1050 and I have to configure IEC61850.

 

In my system I have 3 analog input signals + 14 measurements from power meter device + 64 digital input signals.

 

I have created a 2 datasets in LLN0.

 

Configuration and download of IED is successful if I add 3 analog input signals + 14 measurements from power meter device + 59 digital input signals, when I add one of the last 5 digital signals, a fault that are shown on the next figure appears.

 

When I create a Report Control Block from DataSets, the system again drop.

 

It’s looks like a filled a buffer, as I can see from the next figure?

Attachments (1)
1.jpg 1.jpg
Responses (1)
Martin PLCnext Team
Martin PLCnext Team Accepted Answer Pending Moderation
0
Votes
Undo

Hi Milosav,

Again, this question does not relate to PLCnext Technology, and so these types of questions are not likely to be relevant to other members of the PLCnext Community.

I will ask someone to contact you by email.

And again, you should be able to get direct personal support from your local Phoenix Contact office, or from wherever you buy your Phoenix Contact products.

~ Martin.

Phoenix Contact Electronics Headquarters - PLCnext Runtime Product Management and Support
  1. 2 weeks ago
  2. PLCnext Technology & PLCnext Controls
  3. # 1
  • Page :
  • 1


There are no replies made for this post yet.
However, you are not allowed to reply to this post.