Hello Alex,
looks like the latest FW was installed.
Now the question is why the WBM was not working anymore after the Restart.
Can you check the /var/log/ contents?
What is the State of the PLCs LEDs.
How long did you wait or refresh after the update?
Could it be that your browser was caching the old page? (After a FW Update wbm will need to reload.)
IF nothing works
please try Reset type two.
(
To restore the controller to default setting type 2, proceed as follows:
•Switch off the supply voltage of the controller.
•After the LEDs have gone out, press the reset button.
•Hold the reset button down and switch the supply voltage on.
The RUN and FAIL LEDs light up.
•Press and hold the Reset button until (approx. 30 s) until all LEDs (except LEDs E and D) light up.
•Release the reset button.
The controller is reset to default setting 2.
)
And then do a FW update again.
Phoenix Contact Electronics Headquarter - PLCnext Runtime Product Management and Support