This site uses cookies for functional purposes. To continue please read and agree to our Data Privacy.

By closing this message, you consent to our use of cookies on this device.

PLCnext on Instagram  PLCnext on YouTube Github PLCnext CommunityStore PLCnext Community

  1. bram oostenbrug
  2. PLCnext Engineer
  3. Thursday, 20 June 2019

At the moment I try to implement the new AXL F IOL8 2H - 1027843.

I use the 2019.3 FW and SW version.

On the website I downloaded the FDCML3 file for import. It is included in the Components Area. It seems that this type is restricted for use directly on the Axioline-bus behind the Controller. There was some communication that it could only be used behind a PN BK. This module type is not included in the component area 'Axioline F Profinet'. A newer FDCML3 for the 2701815 can't be found also. How to implement the 1027843 behind the PN BK 2701815?

Second remark.

If I choose to configure the AXL F IOL8 2H behind the Controller on Axioline-bus you should use for Acyclic communication the IOL_Basic Function block and the AsynCom_AXL function block from the AsynCom_6 library. It seems that the IOL_Basic communication block doesn't work properly because I get the wDiagCode 16#C100 wAddDiagCode 16#00000000. It suggested that there is a timeout on Profinet. That doesn't make sense because I use it behind the controller and I have no PN communication.
How to solve this problem.

 

peterdallmann Accepted Answer Pending Moderation
0
Votes
Undo

I can send you a demo project for both application - direct on the controller and on a BK.

  1. more than a month ago
  2. PLCnext Engineer
  3. # 1
bram oostenbrug Accepted Answer Pending Moderation
0
Votes
Undo

Okay. If you have, I would be very happy.

Could you upload it to the Forum?

tnx

 

  1. more than a month ago
  2. PLCnext Engineer
  3. # 2
peterdallmann Accepted Answer Pending Moderation
0
Votes
Undo

I will upload it to the forum today but not later as tomorrow.

Peter Paul

  1. more than a month ago
  2. PLCnext Engineer
  3. # 3
peterdallmann Accepted Answer Pending Moderation
0
Votes
Undo

It is not possible to upload a zip file to the forum. e-mail?

Peter Paul

  1. more than a month ago
  2. PLCnext Engineer
  3. # 4
Manfred Masthoff Accepted Answer Pending Moderation
0
Votes
Undo

Same here. I try to get valid Data from the module, but get nothing. Is it possible to rename the Examples to .pdf and upload them?

I would be very happy if I could get a concrete example.

Gruß, Manfred

  1. more than a month ago
  2. PLCnext Engineer
  3. # 5
  • Page :
  • 1


There are no replies made for this post yet.
However, you are not allowed to reply to this post.